| Last Modified: 11-29-2007 | 1.6 A | |
| Service Category: Brake | Section: Brake (front) | |
| Model Year: 2008 | Model: Sequoia | Doc ID: RM0000012ZC00CX |
| Title: BRAKE (FRONT): FRONT BRAKE: REMOVAL (2008 Sequoia) | ||
REMOVAL
1. REMOVE FRONT WHEEL
2. REMOVE FRONT DISC BRAKE PAD KIT
|
(a) Remove the pin hold clip. NOTICE:
The pin hold clip can be used again if it has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign particles cleaned off. |
(b) Remove the hole pins.
|
(c) Remove the front disc brake anti-rattle spring. NOTICE:
The anti-rattle spring can be used again if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign particles cleaned off. |
|
(d) Remove the 2 pads from the disc brake caliper. |
(e) Remove the No. 1 and No. 2 anti-squeal shims from each pad.
3. DISCONNECT NO. 7 FRONT BRAKE TUBE
|
(a) Using a union nut wrench, disconnect the front brake tube from the disc brake caliper. |
4. DRAIN BRAKE FLUID
NOTICE:
Wash brake fluid off immediately if it is spilled on any painted surface.
5. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH
|
(a) Remove the 2 bolts and disc brake caliper from the knuckle. |
6. REMOVE FRONT DISC
|
(a) Put matchmarks on the front disc and the axle hub if planning to reuse the disc. |
(b) Remove the front disc.
|
|